Deck Ledger Board Vinyl Siding

Flashing a Deck Ledger Board on Vinyl Siding | Family Handyman Attaching a deck ledger board to a vinyl-sided house requires a few extra trim pieces to keep water from leaking behind the siding. Here's a rundown of.

How to Attach a Deck to a House With Vinyl Siding | HomeSteady Sep 26, 2017 ... Cut a section of copper flashing as long as the width of the deck. Slide one side up at least 3 inches behind the vinyl siding. Mold the flashing over the top and in front of the ledger board. Secure with copper nails.

HOMETIME HOW TO, Decks - Preparing Siding for Ledger Measuring Deck The ledger board is attached directly to a house wall after the siding has been cut away, and it supports one side of a deck. ... You will probably end up having to re-mark the locations of your deck surface and ledger board on the walls sheathing after you have removed the necessary pieces of vinyl siding.

Attaching the Ledger Board | Deck Building Project - DecksGo Ledger neatly attached to house. But it's also less labor intensive and uses fewer materials than digging holes and setting another set of posts and beams to create a stand alone deck. There are various ways to attach the ledger but our example is quite common for vinyl clapboard style siding and is waterproof for peace of...

Deck ledger applied over vinyl siding - InterNACHI Inspection Forum I say that it's improperly installed and not allowing ledger board to be tightly installed against the structure and prone to premature failure ... Deck ledger applied over vinyl siding-029-jpg. This was from Friday's inspection, I could put 4 fingers behind the ledger board at both ends.

Flashing a Deck Ledger Board on Vinyl Siding - Pinterest Attaching a deck ledger board to a vinyl-sided house requires a few extra trim pieces to keep water from leaking behind the siding. Here's a rundown of the mate.

How to Attach a Ledger Board to a Vinyl Sided House - Home Guides Properly securing the ledger board is crucial to building a strong, safe deck. The ledger board is a horizontal framing member, usually two-by-10 or two-by-12 lumber, that supports one side of a deck and attaches flat to the wall of a house after removing a section of siding. Deck joists are typically attached to the face of the...