Staking Out a Freestanding Deck

Building a Freestanding Deck in a Seismic Zone | Professional Deck ... Aug 7, 2017 ... To properly locate the footings on a sloped site like this, we like to stake up 2x4s to create a mock footprint of the deck. This simplifies the layout process, and the 2x4s also double as batter boards from which we plumb down to establish finish deck and footing placement. The freestanding deck is located on...

How to Layout a Perfect Rectangle for Deck or Patio ? DIY Projects ... Jul 6, 2017 ... View this quick video tip demonstrating how to make perfectly square angles when laying out a deck, patio or other large rectangular shapes. ... First, stake the location where you want the 90-degree angle and attach two string lines. Attach one of the two lines to a second stake, where you want the first side...

DIY Build a Freestanding Cantilevered Deck - Extreme How To Aug 25, 2010 ... How to Build a Freestanding Cantilevered Deck. ... Unless I was to tear out the ceiling, I wouldn't be able to add nuts and washers to through-bolts on the interior side of the rim joist. And, if I couldn't ... I then ran two new rows of string within the perimeter, staking the location of each support post. I used a...

How to Lay Out a Deck on Un-Level Ground | Home Guides | SF Gate Measure down from the bottom of an exterior door or window and mark the side of the house at the height of the finished deck with a marking crayon. If the deck is free-standing and doesn't attach to a house, drive a 48-inch wood stake several inches into the ground with a steel mallet and mark the height for top of the deck...

Decks.com. Deck Footing Spacing and Layout It is very important to build the deck footings in the right locations. There are two principle methods for accurately laying out the footing locations based on your plans. It usually helps to have the ledger board installed to give you two fixed positions at the house to work off of. Remember that the dimensions on your plan are...

Deck layout procedure after the ledger board is attached How to lay out the deck:once the the ledger board installed against the building that board forms the home-base from which all other deck measurements are made. ... done the level, plumb and square-up of the deck from the ledger board (building attached decks & porches) or from batter boards (for a free-standing deck ).

How to Build a 12 X 12 Freestanding Deck | Hunker Dec 4, 2011 ... As the word implies, a freestanding deck is sometimes referred to as a floating deck and is not attached to any permanent structure. Whether you are building this type of deck... ... Mark the corners for the deck at the desired location. Use a tape measure and hammer a stake into the ground at each corner.

How to start a deck (laying out your post and digging) - YouTube Jun 29, 2013 ... Luke shows how to lay out your deck using a CAD design and the back of the house. Questions: dreamdecks@live.com dreamdecksohio.com.

How to Lay Out a Deck - Better Homes and Gardens Expect to spend four to five hours building batterboards, figuring out the layout, stretching lines, and determining footing locations. To lay out the deck, you need to be able to measure and check for square, fasten screws, and pound stakes. It's also a good ... Drive a stake or landscape spike into the ground to mark the spot.